Requirements for the Calibration of Measuring and Test Equipment
7 Z540.3 Compliance ANSI / NCSL Z540.3 Addressing Global Requirements ANSI / NCSL Z540-1 ISO/IEC 17025 EURAMET/cg-15/v.01 (previously EA 04/13) ILAC-G8 'Where calibrations provide for verification that measurement quantities are within specified tolerances, the probability that incorrect acceptance.
Abstract
This National Standard establishs the technical requirements for the calibration of measuring and test equipment. This is done through the use of a system of functional components. Collectively, these components are used to manage and assure that the accuracy and reliability of the measuring and test equipment are in accordance with identified performance requirements.
In implementing its objective, this National Standard describes the technical requirements for establishing and maintaining: the acceptability of the performance of measuring and test equipment; the suitability of a calibration for its intended application; the compatibility of measurements with the National Measurement System; and the traceability of measurement results to the International System of Units (SI).
Notes
Claudia's Notes:
The ANSI/NCSL Z540.3 has replaced both the ANSI/NCSL Z540.1 and the MIL-STD-45662. You may also want to take a look at ISO-10012, the International Calibration Standard.
To find similar documents by Federal Supply Class Code:
Claudia's Notes:
The ANSI/NCSL Z540.3 has replaced both the ANSI/NCSL Z540.1 and the MIL-STD-45662. You may also want to take a look at ISO-10012, the International Calibration Standard.
To find similar documents by Federal Supply Class Code:
This document comes with our free Notification Service, good for the life of the document.
Ansi Z540 1 Calibration Standard
This document is available in Paper format.
